英文ZSE什么意思？

英文ZSE什么意思？

ZSE-1000 纸张撕裂度测定仪

人工翻译英文

Moreover, fromFig. 1(c), it can be

此外，fromfig。1（C），它可以

found that some of the TiN powders were agglomerated from

发现某些锡粉末的团聚

fine TiN particulates (Fig. 1(c)). 50 wt.% Al2319 and 50 wt.% TiN

精细TiN颗粒（图1（c））。50重量%和50重量%的锡al2319

(corresponding to 32.7 vol.%TiN) powders were mechanically

（对应32.7体积%的锡）的粉末进行机械

blended as feedstocks. For comparison, pure Al2319 coating

混合原料。相比之下，纯al2319涂层

was also deposited. Al plateswere used as substrates andwere

也沉积。铝plateswere用作衬底的

sand-blasted prior to spraying.

喷砂喷涂之前。

The coating cross-sectional structure was observed with

观察了涂层的横截面结构

optic microscopy (OM) and scanning electron microscopy

光学显微镜（OM）、扫描电子显微镜

(SEM). The polished cross-sectionswere etched by a solution of

（SEM）。光交叉sectionswere通过溶液蚀刻

100 ml H2O+3mlHF+6mlHNO3. Estimation of coating porositywas

100毫升H2O + 3mlhf + 6mlhno3。涂层porositywas估计

performed through metallurgical image analyses using

通过金相图像进行分析使用

at least 10 cross-sectional micrographs. Vickers hardness

至少10的横截面的显微照片。维氏硬度

measurement was performed on the polished cross-sections

在抛光横截面进行测量

using a LEITZ microhardness tester with a load of 200 g and a

用Leitz显微硬度计与200克的负载和

dwell time of 15 s. More than 15 values from random locations

15秒的停留时间。15多值随机位置

on the polished cross-section were averaged for calculating

在光滑的截面进行平均计算

the mean hardness. The coating/substrate adhesive strength

平均硬度。涂层/基体的粘结强度

was measured using pull-off test (ASTM C-633-79). The commercially

利用拉拔试验测定（ASTM c-633-79）。商业

available adhesive film (FM 1000), having a nominal

可用的胶膜（调频1000），有一个名义上的

tensile strength up to 60MPa, was used. The assembled test

抗拉强度达到60MPa，使用。组装测试

pieceswere tested with a speed of 0.78mm/min using Estotest

pieceswere速度与0.78mm/min使用estotest测试

50 tensile tester. For each coating, five test specimens were

50拉伸试验机。各涂层的试样，五

used. The fractured surfacewas obtained through bending the

用。发现通过弯曲断裂

substrate to peel the coating.

衬底剥离涂层。

有些词语翻译过来怎么还是他本身啊

我是一句一句翻译的